Switch on to a Smarter Way of Electric Central Heating.
Intelli heat energy efficient electric radiators are revolutionary and offer exceptional heating and control without any pipes or plumbing. These unique electric radiators are very easy to install and are pre-wired. Whether you require whole house heating, or you are replacing panel heaters or storage heaters, intelli heat provides the ideal Electric Central heating system.
How does a electric radiator heat a room by convection? Hot air rises to the ceiling and as it cools on the far side of the ceiling it sinks back down to the floor on the opposite side of the room from the radiator. It will not evenly heat the room. To get the best comfort level, you need a ceiling fan to push the hot air to the floor.
So How Does our Electric Central Heating Actually Work?
All our electric radiators provide responsive and efficient heating using three key components which work together to ensure extremely high levels of energy efficiency, making them truly unique. Each designer electric radiator is fitted with a high quality element that absorbs energy quickly and heats up quickly, it retains the energy but releases it slowly, thus once heated it uses minimal power to maintain the correct temperature required to heat the thermodynamic fluid.
Each radiator is filled with a thermodynamic fluid and our exclusive Advanced Condensing System which is specifically formulated to heat up rapidly and to expand to the entire heat exchange area within the radiator resulting in maximum outer surface hot point effect. Our Patented thermodynamic fluid also has high heat retaining properties allowing the absorbed energy to be used to maintain the thermodynamic fluid’s required temperature for the maximum period of time, therefore requiring minimal power to reheat.The Advanced Condensing System allows NEEDO radiators to recover, through evaporation, energy produced, effectively using heat twice and making the system more efficient.
When activated, the radiator will draw full power until the required temperature as set by the thermostat is achieved, this is normally within 10 minutes. At that point the radiator will cease to draw power, the thermodynamic fluid will have rapidly expanded and the radiator will have 100% surface hot point effect. Due to the tungsten element’s slow release of energy and the thermodynamic fluid’s heat retaining qualities, the radiator will continue to emit heat using minimal power to maintain the required temperature.